Inpak Systems - Product Lines

Taylor Products : BDAP Auger Packer

The Taylor BD Heavy Duty Auger Packer for open mouth bags includes the following components:

Carbon steel base framework, belt shields, weigh mast assembly, inlet hopper, and Inflatable Spout. All carbon steel framework and components are finished with an industrial acrylic polyurethane enamel.

The flanged inlet hopper will hold approximately 1 cubic foot of product, inlet height of 82 inches. The hopper has a drop bottom clean out door with a safety interlock switch. An agitator system in the hopper prevents product bridging. The agitator is available with a paddle, finger, or ribbon - style blades. A gear reduction drive is provided to power the agitator and is belt driven from the motor. Standard motor is 3 HP TEFC, 230/460 volt 3 phase 60 Hz, with motor starter included in NEMA 12 enclosure.

The auger feed screw is single speed standard. The auger is belt driven with the motor The auger is mounted through the bottom of the hopper with external bearings. The rear bearing is an air purge seal with Teflon packing glands. The auger delivers product to the bag through the fill spout.

The inflatable bag clamp is mounted on a weigh mast assembly, suspended from a 500 pound capacity electronic load cell, with double flex leaves supporting the mast top and bottom to equalize the dead load. Once the bag is placed on the fill spout, the inflatable bladder expands to hold the bag in place.

The controls and weigh meter are enclosed in a NEMA 12 panel. The weigh meter includes a 3 1/2 digit LED readout calibrated in pounds and 1/10'" of a pound, zero adjustment knob, and cutoff set point. controls include power on/off, and start/stop controls.

Requires 115 volt single phase 60 Hz for controls, 230/460 volt 3 phase 60 Hz. For motor, and 80 psi compressed air at 3 CFM.

NOTE: Inflatable Bladder can not hold bags weighing more that 60 pounds. If bags weighing more than sixty pounds are needed they will require the platform option.

SYSTEMS INTEGRATION